Re: [CAD_CAM_EDM_DRO] Decent Table Top mill vise?

timgoldstein wrote:

> On our Haas machine using a high quality vise is pretty much industry standard for work holding short run and one off parts. On the table top machines, the vices I have used (Sherline, Taig) are inconvenient to use and cause a huge loss in the setup rigidity.
>
> Has anyone seen or used an appropriately sized vise for these small machines that works as well as the big Parlec and Kurt vices we use on the big boy machines?
>
>

There are plenty of smaller milling vises available. You might look
under "toolmaker's vise". I got a little tilting vise that fits fairly
well on my minimill, it might work on a Taig.

Jon