Gecko 203V disable light with Smoothstepper
Posted by
jimmy_staton
on 2011-09-23 09:51:18 UTC
I'm running a SmoothStepper with 3 X 203V Gecko's all is fine testing the drives
at about 30 Inches a min but If I get much above that the 203V for that axis set the Red disable light and I have to recycle the power connected to the 203V's to reset it.
It also did the same thing running for a parallel port so I don't thing it's the controller.
I have shield cable connected to the Step, Dir, Ena and GND I am run at 20,000 steps
per inch on ball screw, am I just trying to get too high a inch Per/ min from these drivers?
at about 30 Inches a min but If I get much above that the 203V for that axis set the Red disable light and I have to recycle the power connected to the 203V's to reset it.
It also did the same thing running for a parallel port so I don't thing it's the controller.
I have shield cable connected to the Step, Dir, Ena and GND I am run at 20,000 steps
per inch on ball screw, am I just trying to get too high a inch Per/ min from these drivers?
Discussion Thread
jimmy_staton
2011-09-23 09:51:18 UTC
Gecko 203V disable light with Smoothstepper
bob campbell
2011-09-23 11:41:11 UTC
RE: [CAD_CAM_EDM_DRO] Gecko 203V disable light with Smoothstepper
jimmy_staton
2011-09-23 13:13:46 UTC
Re: Gecko 203V disable light with Smoothstepper
jimmy_staton
2011-10-01 09:05:26 UTC
Re: Gecko 203V disable light with Smoothstepper