Re: Basic questions
Posted by
polaraligned
on 2012-01-06 04:50:30 UTC
<dave_mucha@...> wrote:
Scott
>Curious what kind of cutter you use that leaves a clean edge on the traces? I assume that it is very small so the traces can be close.
> in doing circuit boards...
> Dave
>
Scott
Discussion Thread
jeffalanp
2012-01-02 10:52:18 UTC
Xylotex: Reduced Prices on System Kits
Ron Thompson
2012-01-02 11:10:30 UTC
Re: [CAD_CAM_EDM_DRO] Xylotex: Reduced Prices on System Kits
Gordon Anderson
2012-01-02 12:16:10 UTC
Basic questions
Ron Thompson
2012-01-02 13:00:55 UTC
Re: [CAD_CAM_EDM_DRO] Basic questions
Jack McKie
2012-01-02 13:11:31 UTC
Re: [CAD_CAM_EDM_DRO] Basic questions
Tom
2012-01-02 13:14:29 UTC
Re: Basic questions
Jack McKie
2012-01-02 13:16:55 UTC
Re: [CAD_CAM_EDM_DRO] Basic questions
Ron Thompson
2012-01-02 13:46:20 UTC
Re: [CAD_CAM_EDM_DRO] Basic questions
jeffalanp
2012-01-02 16:20:03 UTC
Re: Xylotex: Reduced Prices on System Kits
Ron Thompson
2012-01-02 16:34:57 UTC
Re: [CAD_CAM_EDM_DRO] Re: Xylotex: Reduced Prices on System Kits
David G. LeVine
2012-01-02 16:47:28 UTC
Re: [CAD_CAM_EDM_DRO] Basic questions
jeffalanp
2012-01-02 17:10:16 UTC
Re: Xylotex: Reduced Prices on System Kits
Jack
2012-01-02 18:11:59 UTC
Re: Basic questions
Jack McKie
2012-01-02 18:20:09 UTC
Re: [CAD_CAM_EDM_DRO] Re: Xylotex: Reduced Prices on System Kits
Gordon Anderson
2012-01-03 07:23:44 UTC
Re: [CAD_CAM_EDM_DRO] Basic questions
Gordon Anderson
2012-01-03 07:23:58 UTC
Re: [CAD_CAM_EDM_DRO] Basic questions
Brian Worth
2012-01-03 07:24:04 UTC
Re: [CAD_CAM_EDM_DRO] Basic questions
bob campbell
2012-01-03 07:24:11 UTC
RE: [CAD_CAM_EDM_DRO] Basic questions
John Jackson
2012-01-04 20:08:18 UTC
Re: Basic questions
Roland Jollivet
2012-01-05 01:25:32 UTC
[CAD_CAM_EDM_DRO] Re: Basic questions
turbulatordude
2012-01-05 03:39:58 UTC
Re: Basic questions
polaraligned
2012-01-06 04:50:30 UTC
Re: Basic questions
turbulatordude
2012-01-06 20:19:02 UTC
Re: Basic questions