Re: [CAD_CAM_EDM_DRO] Re: Dan Mauch 3 axis chopper

thanks, Dan, but I have a physical board in front of me and the
directions you supplied. I was contacted off list by someone who
thought I might have pix or schematics. I do not, and your communication
to me was that you didn't have them either, so I asked the list. So I
wouldn't need anyone to jump through the hoops of supplying a picture -
however, if that picture were to be annotated :o)) As I recall, there
were a couple places where I had to guess components....I think they
were covered by chip holders or something. I'll look again and maybe
ask specifically if I have problems.

Again, THANKS Dan Mauch for this board and the documentation!!

Chuck

On 7/21/2012 10:05 AM, Dan Mauch wrote:
>
> I was scrounging though a old box and found one of those three axis
> drivers
> dating back to the 03/19/2001 version of the L297/l298 boards. If I take
> pictures of that board will it help?.
>
> Dan
>
> Dan Mauch
>
> www.camtronics-cnc.com
>
> dmauch@... <mailto:dmauch%40camtronics-cnc.com>
>
> Stepper and servo motors
>
> Kits, assembled and custom CNC using Gecko products.
>
> [Non-text portions of this message have been removed]
>
>



[Non-text portions of this message have been removed]