RE: [CAD_CAM_EDM_DRO] Re: Lost steps

> Additionally:
> In fooling around and changing motors I found that if I turned off
> the
> driver with EMC still running, changed motors plugged into the Y
> axis,
> for instance, turned the driver back on, the motor did not lock and
> would not move until I rebooted EMC, not the computer just EMC.
> Can someone explain.

If you power down the driver and repower it the motors will not be energized
until the driver receives a step for the axis. Not quite sure how the
restarting EMC affects this other than on startup it may send out a pulse on
each axis.

Tim
[Denver, CO]