CAD CAM EDM DRO - Yahoo Group Archive

List of Gcode "flavors"

Posted by ballendo@y...
on 2000-09-02 15:35:33 UTC
Hello All,

I mentioned before the possibility of using the resources of the list
to create a cross-reference of the different "flavors" of G and M
codes.

I think this would be VERY useful. A lot of people are writing G code
controls and we will all benefit if the codes used are standardized
(as much as possible). We also would benefit when using existing
controls/software by knowing what the various post-processors are
assuming.

This project will need input from some who probably won't immediately
benefit (the guys who are using their CAD/CAM and controls without a
hitch don't need this list, but ARE in a position to help others)

The first step is getting the lists of G and M codes in one place.
Then we could decide how best to cross-reference the information.

Any other interest in this?
How best to proceed?

Ballendo

Discussion Thread

ballendo@y... 2000-09-02 15:35:33 UTC List of Gcode "flavors" ballendo@y... 2000-09-02 19:02:32 UTC Re: List of Gcode "flavors" ballendo@y... 2000-09-02 21:07:34 UTC Re: Re: List of Gcode "flavors" Paul Corner 2000-09-03 07:23:39 UTC Re: [CAD_CAM_EDM_DRO] Re: List of Gcode "flavors" ballendo@y... 2000-09-03 11:34:39 UTC Re: Re: List of Gcode "flavors" Paul Corner 2000-09-04 15:48:33 UTC [CAD_CAM_EDM_DRO] Re: List of Gcode "flavors" ballendo@y... 2000-09-04 20:56:27 UTC Re: Re: List of Gcode "flavors" Paul Corner 2000-09-05 15:10:25 UTC Re: [CAD_CAM_EDM_DRO] Re: Re: List of Gcode "flavors" Darrell 2000-09-05 15:25:02 UTC Re: [CAD_CAM_EDM_DRO] Re: Re: List of Gcode "flavors" Dave Seal 2000-09-05 16:34:48 UTC Re: List of Gcode "flavors" diazden 2000-09-07 08:27:33 UTC Re: [CAD_CAM_EDM_DRO] Re: Re: List of Gcode "flavors" Jon Elson 2000-09-07 14:18:37 UTC Re: [CAD_CAM_EDM_DRO] Re: Re: List of Gcode "flavors" diazden 2000-09-07 16:23:49 UTC Re: [CAD_CAM_EDM_DRO] Re: Re: List of Gcode "flavors"