Re: [CAD_CAM_EDM_DRO] Re: Re: List of Gcode "flavors"

M codes vary a lot because along with the "standard" ones you also have the
programmable ones
and the "special" ones.
Darrell AL7DO
http://www.machinemaster.com

----- Original Message -----
From: "Paul Corner" <Paul.Corner@...>
To: <CAD_CAM_EDM_DRO@egroups.com>
Sent: Tuesday, September 05, 2000 1:48 PM
Subject: Re: [CAD_CAM_EDM_DRO] Re: Re: List of Gcode "flavors"


>
>
> Hi Ballendo, Bill,...
>
> I've found a list from Microkinetics which I shall add soon...
> Also had a chat with HAAS and had a list for the VF machining centers
faxed
> over. During the discussion, the companion subject of M codes (or words)
was
> raised - there appears to be a greater variation with these than G codes,
So I
> will includ them in my list.
> I doubt whether I'll be able to do much tomorrow, it looks like I will
have to
> do some real work :-{
>
> Still leaves the original question unanswered though - HTML, plain text,
or M$
> Excel data format ?
>
> Regards, Paul.
>
> ( Dave - I'll try to get a copy out to you by the weekend )
>
> > << What format is best for you - >>
> > Why not consider posting them in the files section at CAD_Cam.......
> > bill
> >
> > Thank you, Bill. I really have high hopes for this project. It could
> > help a LOT of people.
> >
> > Ballendo
> >
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>
>