Re: [CAD_CAM_EDM_DRO] Re: Re: List of Gcode "flavors"

Ballendo;
let me put my 2 cents worth on this matter
one of the most useful features of the big machines is the ability to be able to
perform calculation blocks, just the other day I have to make a 475 tooth gear
as 475 is not divisible by 360 I could not use incremental because the error will
creep and about 380th tooth it would be 1\2 tooth out , so I either have to
put 475 lines of code or with about 4 lines on a good calculation block it
will do the job perfectly , and it did it ,so now I can use that program to do any
number of divisions just by changing a few parameters in the program
regards
mariano


ballendo@... wrote:

>
> Paul wrote:
> >Will you be interested in the three digit codes or just the two
> >digit ones ?
> >What about the 'canned cycles' - should these be included in any
> >lists ?
> >Regards, Paul.
>
> Paul, thanks for the response.
>
> For the list to be truly useful, it will need to be comprehensive, so
> let's include the three-digit codes and DEFINITELY the canned cycles.
> Emphasis because canned cycles are one of the areas where MFR's play
> by their own rules.
>
> Ballendo
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager