Re: DRO BOARDS ARE IN

I would be interested in one DRO board if you have any left. Just tell me
how much and where to send it.
-----Original Message-----
From: Dan Mauch <dmauch@...>
To: CAD_CAM_EDM_DRO@onelist.com <CAD_CAM_EDM_DRO@onelist.com>
Date: Monday, June 28, 1999 6:40 AM
Subject: Re: [CAD_CAM_EDM_DRO] DRO BOARDS ARE IN

>From: "Dan Mauch" <dmauch@...>
>
>I received the DRO boards on schedule and have assembled one to make ensure
>there were no hidden problems. I connected it as a two axis board then I
>added the other chip and ran it as a 4 axis board. The board worked great
>with both the 1000 line rotary encoder and the 360 line linear encoder

strip

>from US digital. I check it in one inch against a dial indicator and
>everything was right on the money. For those that use metric, Tom's program
>works fine in the metric mode.
>The fourth axis is is degrees minutes and seconds.
>I am very pleased with the with these boards and you need to thank Tom
>Kulaga who wrote the program and came up with the concept.
>I had some extra boards make solet me know if you're intereested..
>I will write up the documentation for assembly today. For those that have
>all ready ordered boards I have contacted you by email.
>Dan
>Dan
>
>
>--------------------------- ONElist Sponsor ----------------------------
>
>ONElist: where real people with real interests get connected.
>http://www.onelist.com
>Join a new list today!
>
>------------------------------------------------------------------------
>Welcome to CAD_CAM_EDM_DRO@...,an unmodulated list for the

discussion of shop built systems in the above catagories.

>To Unsubscribe, read archives, change to or from digest.
>Go to: http://www.onelist.com/isregistered.cgi
>Log on, and you will go to Member Center, and you can make changes there.
>bill,
>List Manager