Re: DRO BOARDS ARE IN

Add me to the list for leftovers as well, please.

Marshall Pharoah
Software Engineer

-----Original Message-----
From: Jack Noble <apple@...>
To: CAD_CAM_EDM_DRO@onelist.com <CAD_CAM_EDM_DRO@onelist.com>
Date: Monday, June 28, 1999 9:43 AM
Subject: Re: [CAD_CAM_EDM_DRO] DRO BOARDS ARE IN

>From: "Jack Noble" <apple@...>
>
>I would be interested in one DRO board if you have any left. Just tell me
>how much and where to send it.
>-----Original Message-----
>From: Dan Mauch <dmauch@...>
>To: CAD_CAM_EDM_DRO@onelist.com <CAD_CAM_EDM_DRO@onelist.com>
>Date: Monday, June 28, 1999 6:40 AM
>Subject: Re: [CAD_CAM_EDM_DRO] DRO BOARDS ARE IN
>
>
>>From: "Dan Mauch" <dmauch@...>
>>
>>I received the DRO boards on schedule and have assembled one to make

ensure

>>there were no hidden problems. I connected it as a two axis board then I
>>added the other chip and ran it as a 4 axis board. The board worked great
>>with both the 1000 line rotary encoder and the 360 line linear encoder
>strip
>>from US digital. I check it in one inch against a dial indicator and
>>everything was right on the money. For those that use metric, Tom's

program

>>works fine in the metric mode.
>>The fourth axis is is degrees minutes and seconds.
>>I am very pleased with the with these boards and you need to thank Tom
>>Kulaga who wrote the program and came up with the concept.
>>I had some extra boards make solet me know if you're intereested..
>>I will write up the documentation for assembly today. For those that have
>>all ready ordered boards I have contacted you by email.
>>Dan
>>Dan
>>
>>
>>--------------------------- ONElist Sponsor ----------------------------
>>
>>ONElist: where real people with real interests get connected.
>>http://www.onelist.com
>>Join a new list today!
>>
>>------------------------------------------------------------------------
>>Welcome to CAD_CAM_EDM_DRO@...,an unmodulated list for the
>discussion of shop built systems in the above catagories.
>>To Unsubscribe, read archives, change to or from digest.
>>Go to: http://www.onelist.com/isregistered.cgi
>>Log on, and you will go to Member Center, and you can make changes there.
>>bill,
>>List Manager
>
>
>--------------------------- ONElist Sponsor ----------------------------
>
>Looking for a new hobby? Want to make a new friend?
>http://www.onelist.com
>Come join one of 175,000 e-mail communities at ONElist!
>
>------------------------------------------------------------------------
>Welcome to CAD_CAM_EDM_DRO@...,an unmodulated list for the

discussion of shop built systems in the above catagories.

>To Unsubscribe, read archives, change to or from digest.
>Go to: http://www.onelist.com/isregistered.cgi
>Log on, and you will go to Member Center, and you can make changes there.
>bill,
>List Manager
>