Re: [CAD_CAM_EDM_DRO] Newbie pocket milling question
Posted by
Anne Ogborn
on 2000-10-08 13:26:30 UTC
PMeinhard@... wrote:
I can use a 3mm shaft.
I've put a dxf and a dwg file of the cutters at
http://www.idiom.com/~anniepoo/eng/cutter.dwg
http://www.idiom.com/~anniepoo/eng/cutter.dxf
Basicly a radius end and a square end 2 flute mill,
1/32" dia. by 1/16" deep cut, with an extended shaft 1/4" long.
Does anybody else think this is crazy to cut wax with this tool?
>Great!
> Hi Anne
> Can You also use a 3mm or 6mm shaft ?
> If so , and if you can sent a picture/drawing of the cutter You need perhaps
> I can make You a few. We are manufactoring Turbo and compressor wheels from
> 16 - 1600 mm Diameter and Turbo-molekular pumps . I think one of those tools
> will fit to your problem or if not, for engraving of Knife-cylinders we make
> the tools ourselves (carbide-Steel).
> Peter Meinhard
I can use a 3mm shaft.
I've put a dxf and a dwg file of the cutters at
http://www.idiom.com/~anniepoo/eng/cutter.dwg
http://www.idiom.com/~anniepoo/eng/cutter.dxf
Basicly a radius end and a square end 2 flute mill,
1/32" dia. by 1/16" deep cut, with an extended shaft 1/4" long.
Does anybody else think this is crazy to cut wax with this tool?
Discussion Thread
Anne Ogborn
2000-10-06 22:34:43 UTC
Newbie pocket milling question
Rich D.
2000-10-06 22:50:10 UTC
Re: [CAD_CAM_EDM_DRO] Newbie pocket milling question
Rich D.
2000-10-06 22:53:39 UTC
Re: [CAD_CAM_EDM_DRO] Newbie pocket milling question
Jon Anderson
2000-10-06 23:30:42 UTC
Re: [CAD_CAM_EDM_DRO] Newbie pocket milling question
Jon Elson
2000-10-07 14:00:45 UTC
Re: [CAD_CAM_EDM_DRO] Newbie pocket milling question
PMeinhard@a...
2000-10-07 14:24:28 UTC
Re: [CAD_CAM_EDM_DRO] Newbie pocket milling question
Rick Dulas
2000-10-07 14:51:20 UTC
Re: [CAD_CAM_EDM_DRO] Newbie pocket milling question
Anne Ogborn
2000-10-08 13:26:30 UTC
Re: [CAD_CAM_EDM_DRO] Newbie pocket milling question