Re: [CAD_CAM_EDM_DRO] Wigglers and Tricks

Use the point and put just enough of the point in the hole
to touch the edge of the hole. When you move a wiggler away
from contact, while it is spinning, it will snap into
alignment as soon as it loses contact with the part. Find
the 9 O'clock point of the hole by moving up and down in Y
until you locate the left most position in X. Then moving
only X, find the right side of the hole. The center is half
of the distance traveled in X.
Darrell

From: "Joe Vicars" <jvicars@...>

> The only remaining trick with the wiggler is finding

the center of

> an already made hole. I would like someone to tell me how

this is done.

>