Re: [CAD_CAM_EDM_DRO] Lathe Software question

on 2000-10-10 22:24:44 UTC

In a message dated 10/10/00 9:12:20 PM Mountain Daylight Time,
mr.c@... writes:

<< This was for
the x axis on my South Bend lathe for a cnc conversion. >>

Carey, what CAM software are you using with the Southbend Lathe? Comments?
thanks,
bill

Discussion Thread

wanliker@a... 2000-10-10 22:24:44 UTC Re: [CAD_CAM_EDM_DRO] Lathe Software question Carey L. Culpepper 2000-10-11 06:14:03 UTC Re: [CAD_CAM_EDM_DRO] Lathe Software question ballendo@y... 2000-10-11 17:47:33 UTC Re: Lathe Software question Carey L. Culpepper 2000-10-11 18:08:52 UTC Re: [CAD_CAM_EDM_DRO] Re: Lathe Software question Alison & Jim Gregg 2000-10-11 19:42:57 UTC Re: [CAD_CAM_EDM_DRO] Re: Lathe Software question Carey L. Culpepper 2000-10-12 06:42:51 UTC Re: [CAD_CAM_EDM_DRO] Re: Lathe Software question Alison & Jim Gregg 2000-10-12 16:52:28 UTC Re: [CAD_CAM_EDM_DRO] Re: Lathe Software question