Re: Lathe Software question

Carey wrote:

>I am using CncPRO.
><snip>Particularly when the machine did a move Saturday that was not
>in the program. It took off in a rapid feed to who knows where. I
>looked at the gcode and the move wasn't there. Maybe something to do
>with the notebook that I am using to run the machine.I backed up and
>ran the same program again andit was ok. Go figure.

Carey,

Was this "extra" move on the Z axis??!!

I have also seen some "unexplained" Z axis moves when using CncPro!
Also NOT in the program. So far, I have been blaming the machine, but
recently, began to suspect the software.

Do you (or anyone else) have addtional info Re: extraneous moves in
Doug Yeagers' CncPRO?

Ballendo