CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: Lathe Software question

on 2000-10-11 19:42:57 UTC
Hi Carey

Sounds like random (electrical) noise getting into the system somehow.

Perhaps checking the grounding / bonding between the laptop and the system
might be a way to go.

Jim Gregg

At 09:05 PM 10/11/00 -0400, you wrote:
>Ballendo: Yep, it was the z axis and it was a rapid move. Zip-crunch-
>dive for the escape key. Lots of pulses came from somewhere at the wrong
>time. Several times I encountered something else that was strange. While
>setting my coordinates after a tool change, I would set one axis and jog
>to a different point to set the other axis only to find that the one
>already set was making big numbers like a half inch move showing ten
>inches or something like that. I checked the settings file and came back
>and it was normal. I again figured it was the notebook computer doing
>strange things. It has not done that for a while.Hmmmm.
>Carey
>Addresses:
>Post message: CAD_CAM_EDM_DRO@egroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
>List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
>Moderator: jmelson@... [Moderator]
>URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
>FAQ: http://www.ktmarketing.com/faq.html
>bill,
>List Manager
>

Discussion Thread

wanliker@a... 2000-10-10 22:24:44 UTC Re: [CAD_CAM_EDM_DRO] Lathe Software question Carey L. Culpepper 2000-10-11 06:14:03 UTC Re: [CAD_CAM_EDM_DRO] Lathe Software question ballendo@y... 2000-10-11 17:47:33 UTC Re: Lathe Software question Carey L. Culpepper 2000-10-11 18:08:52 UTC Re: [CAD_CAM_EDM_DRO] Re: Lathe Software question Alison & Jim Gregg 2000-10-11 19:42:57 UTC Re: [CAD_CAM_EDM_DRO] Re: Lathe Software question Carey L. Culpepper 2000-10-12 06:42:51 UTC Re: [CAD_CAM_EDM_DRO] Re: Lathe Software question Alison & Jim Gregg 2000-10-12 16:52:28 UTC Re: [CAD_CAM_EDM_DRO] Re: Lathe Software question