CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: Response - The Saga

Posted by Matt Shaver
on 2000-10-12 20:15:34 UTC
> From: Art Fenerty <fenerty@...>
> I do have a question though, how many pulses/second are actually required
> for most people. A VXD is not very
> hard to write for up to 8192 pulses per second, but get more difficult at
> 40000 or so. I use about 4000
> or so pulses per second on my machine, but how many pulses does the average
> user require. If I'm going to do this, I might as well make it for most
> users.

Let's say I had a machine with 5tpi screws, 2:1 reduction from motor to
screw, 200 step/rev motors and I wanted a basic unit of movement of .00025"
(I'm half stepping the motor) with a max feed rate of 120"/min. That works
out to 8kHz at 120"/min. I'd be happy with that for my stepper applications.
I'd like the following output step rates:

8000 Hz
7999 Hz
7998 Hz
<...>
3 Hz
2 Hz
1 Hz
.9 Hz
etc.

Can this be done without locking up the GUI? If so, how?

Matt

Discussion Thread

Joe Vicars 2000-10-10 10:26:20 UTC Response - The Saga Anne Ogborn 2000-10-10 12:39:31 UTC Re: [CAD_CAM_EDM_DRO] Response - The Saga ballendo@y... 2000-10-10 18:32:23 UTC Response - The Saga Art Fenerty 2000-10-11 13:06:25 UTC Re: [CAD_CAM_EDM_DRO] Response - The Saga ballendo@y... 2000-10-11 22:47:38 UTC Re: Response - The Saga Art Fenerty 2000-10-12 11:28:34 UTC Re: [CAD_CAM_EDM_DRO] Re: Response - The Saga Ron Ginger 2000-10-12 12:29:42 UTC Re: [CAD_CAM_EDM_DRO] Re: Response - The Saga ballendo@y... 2000-10-12 15:48:04 UTC Re: Re: Response - The Saga Matt Shaver 2000-10-12 20:15:34 UTC Re: [CAD_CAM_EDM_DRO] Re: Response - The Saga Art Fenerty 2000-10-13 12:01:33 UTC Re: [CAD_CAM_EDM_DRO] Re: Response - The Saga