Re: [CAD_CAM_EDM_DRO] Re: Response - The Saga

Ballendo:

Unregistered only, of course. The registered version works forever. The
program will actually start to jump lines of g-code after an hour or so. I
should have a message box open up to tell the user his time just expired.
( hmmm, next version).
I do have a question though, how many pulses/second are actually required
for most people. A VXD is not very
hard to write for up to 8192 pulses per second, but get more difficult at
40000 or so. I use about 4000
or so pulses per second on my machine, but how many pulses does the average
user require. If I'm going to do this, I might as well make it for most
users.
When I re-write the g-code translator, I'll try to incorporate everything
I've learned here in the past few months. Hopefully MonsterControlCNC
version 1.0 will
be a vast improvement over MasterControl version 3.xx,
although it does work quite well.

Thanks,
Art
.

----- Original Message -----
From: <ballendo@...>
To: <CAD_CAM_EDM_DRO@egroups.com>
Sent: Wednesday, October 11, 2000 10:47 PM
Subject: [CAD_CAM_EDM_DRO] Re: Response - The Saga


> Art,
>
> Excellent post. Thank you!
> Looking forward to your VXD!
>
> Ballendo
>
> P.S. Referring to the below quote. Unregistered only or...?
>
> >It actually will become somewhat inaccurate after about an hour of
> usage.
>
>
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>