Re: [CAD_CAM_EDM_DRO] Re: leadscrew bearings / machine design(2nd gif dwg)

In a message dated 10/25/2000 12:32:45 PM Hawaiian Standard Time,
r_fl_z@... writes:

<< So while it makes a very nice drawing of the internals, no information on
the actual clamp up
mechanism is available.

Thanks again for your time.

Ron >>
Ron,
I can't figure out what exactly you need. They have some designs where
there is a finely threaded ring which screws in and clamps the two bearings
inside of the bore. Some have a ring with a bolt hole pattern, there are
several socket head cap screws doing the actual clamping. If you could
explain exactly what you need, I can take a picture or draw up a quick sketch.

Peter
THRD, Inc.