Re: [CAD_CAM_EDM_DRO] Re: leadscrew bearings / machine design(2nd gif dwg)

That picture at the ..nookind...link is EXACTLY what I described earlier!

Smoke

-----Original Message-----
From: r_fl_z@... <r_fl_z@...>
To: CAD_CAM_EDM_DRO@egroups.com <CAD_CAM_EDM_DRO@egroups.com>
Date: Wednesday, October 25, 2000 11:46 PM
Subject: [CAD_CAM_EDM_DRO] Re: leadscrew bearings / machine design(2nd gif dwg)


Peter:

Most excellent! Exactly what I've been looking for.

Thank you very much,

Ron

--- In CAD_CAM_EDM_DRO@egroups.com, ptengin@a... wrote:
> In a message dated 10/25/2000 5:13:07 PM Hawaiian Standard Time,
> r_fl_z@h... writes:
>
> << Peter:
>
> Just to be sure that I hadn't missed anything, I reviewed your
links
> again. I didn't :)
>
> The closest I saw of a useable stackup was the EZMount sketch on
> approx. p63 on the first link. In looking at this sketch, it
occured
> to me that perhaps the hole in the housing had NO internal steps
to
> react the thrust load.
>
> If this is the design, then all of the thrust would be removed via
> the bearing plate fasteners, with the bearing taking only radial
> loads. Do you think this is what they are doing? This is a new
> concept, and one not discussed within the group in this thread.
>
> Thanks,
>
> Ron >>
>
> Ron,
>
> I just checked. You are right, I had linked you to a catalog cut
that does
> not show the cross section of the devices in question. The correct
link is <A
> HREF="http://nookind.com/pdf/powertrac11.pdf">Power trac section
11</A>.
>
>
> Note the cut away view on the first page. If this don't do it, I
don't know
> what will :)
>
> Peter
> THRD, Inc.


eGroups Sponsor


Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.

Addresses:
Post message: CAD_CAM_EDM_DRO@egroups.com
Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
Moderator: jmelson@... [Moderator]
URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
FAQ: http://www.ktmarketing.com/faq.html
bill,
List Manager



[Non-text portions of this message have been removed]