Re: leadscrew bearings / machine design(2nd gif dwg)

Peter:

I feel like you and the other list members have helped me quite a
bit. I think I can produce a workable design based on the comments of
the group.

What I've been looking for, and what started this thread, is a sketch
showing the thrust bearing installation similar to the sketches upped
to the file section.

My appologies if your link provided one and I missed it, but I looked
through carefully (I thought) and didn't see one detailing the entire
stackup.

Thanks,

Ron

--- In CAD_CAM_EDM_DRO@egroups.com, ptengin@a... wrote:
> In a message dated 10/25/2000 12:32:45 PM Hawaiian Standard Time,
> r_fl_z@h... writes:
>
> << So while it makes a very nice drawing of the internals, no
information on
> the actual clamp up
> mechanism is available.
>
> Thanks again for your time.
>
> Ron >>
> Ron,
> I can't figure out what exactly you need. They have some designs
where
> there is a finely threaded ring which screws in and clamps the two
bearings
> inside of the bore. Some have a ring with a bolt hole pattern,
there are
> several socket head cap screws doing the actual clamping. If you
could
> explain exactly what you need, I can take a picture or draw up a
quick sketch.
>
> Peter
> THRD, Inc.