Re: leadscrew bearings / machine design(2nd gif dwg)

--- In CAD_CAM_EDM_DRO@egroups.com, "Smoke" <Smoke@5...> wrote:
> That picture at the ..nookind...link is EXACTLY what I described
earlier!
>
> Smoke
>
> -----Original Message-----
> From: r_fl_z@h... <r_fl_z@h...>
> To: CAD_CAM_EDM_DRO@egroups.com <CAD_CAM_EDM_DRO@egroups.com>
> Date: Wednesday, October 25, 2000 11:46 PM
> Subject: [CAD_CAM_EDM_DRO] Re: leadscrew bearings / machine design
(2nd gif dwg)
>
>
> Peter:
>
> Most excellent! Exactly what I've been looking for.
>
> Thank you very much,
>
> Ron
>
>
>
> --- In CAD_CAM_EDM_DRO@egroups.com, ptengin@a... wrote:
> > In a message dated 10/25/2000 5:13:07 PM Hawaiian Standard Time,
> > r_fl_z@h... writes:
> >
> > << Peter:
> >
> > Just to be sure that I hadn't missed anything, I reviewed your
> links
> > again. I didn't :)
> >
> > The closest I saw of a useable stackup was the EZMount sketch on
> > approx. p63 on the first link. In looking at this sketch, it
> occured
> > to me that perhaps the hole in the housing had NO internal steps
> to
> > react the thrust load.
> >
> > If this is the design, then all of the thrust would be removed
via
> > the bearing plate fasteners, with the bearing taking only radial
> > loads. Do you think this is what they are doing? This is a new
> > concept, and one not discussed within the group in this thread.
> >
> > Thanks,
> >
> > Ron >>
> >
> > Ron,
> >
> > I just checked. You are right, I had linked you to a catalog
cut
> that does
> > not show the cross section of the devices in question. The
correct
> link is <A
> > HREF="http://nookind.com/pdf/powertrac11.pdf">Power trac section
> 11</A>.
> >
> >
> > Note the cut away view on the first page. If this don't do it, I
> don't know
> > what will :)
> >
> > Peter
> > THRD, Inc.
>
>
> eGroups Sponsor
>
>
> Welcome to CAD_CAM_EDM_DRO@e...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@a...
> Moderator: jmelson@a... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>
>
>
> [Non-text portions of this message have been removed]