Re: [CAD_CAM_EDM_DRO] G201 Improvements
Posted by
ptengin@a...
on 2000-10-29 13:18:54 UTC
In a message dated 10/29/2000 4:01:42 AM Hawaiian Standard Time,
dmauch@... writes:
<< One other suggestion is to replace the LED on the board with a polarized
two
pin header so that one can bring the LED out to a panel without having to
add circuitry.
All in favor say Aye!
Dan >>
Aye,
Peter
THRD, Inc.
Now saving to buy three G320's (hope for same header pins on it).
dmauch@... writes:
<< One other suggestion is to replace the LED on the board with a polarized
two
pin header so that one can bring the LED out to a panel without having to
add circuitry.
All in favor say Aye!
Dan >>
Aye,
Peter
THRD, Inc.
Now saving to buy three G320's (hope for same header pins on it).
Discussion Thread
Mariss Freimanis
2000-10-28 21:28:40 UTC
G201 Improvements
ballendo@y...
2000-10-29 00:05:30 UTC
re: G201 Improvements
ptengin@a...
2000-10-29 01:45:19 UTC
Re: [CAD_CAM_EDM_DRO] G201 Improvements
Wally K
2000-10-29 03:35:41 UTC
Re: G201 Improvements
Dan Mauch
2000-10-29 06:00:50 UTC
Re: [CAD_CAM_EDM_DRO] G201 Improvements
Tim Goldstein
2000-10-29 06:59:00 UTC
RE: [CAD_CAM_EDM_DRO] G201 Improvements
ballendo@y...
2000-10-29 13:11:45 UTC
Re: G201 Improvements
ptengin@a...
2000-10-29 13:18:54 UTC
Re: [CAD_CAM_EDM_DRO] G201 Improvements
Mariss Freimanis
2000-10-29 13:30:00 UTC
Re: G201 Improvements
ballendo@y...
2000-10-29 13:39:25 UTC
Re: G201 Improvements
Wally K
2000-10-29 14:03:09 UTC
Re: G201 Improvements
ballendo@y...
2000-10-29 14:36:07 UTC
Re: G201 Improvements
Dan Mauch
2000-10-29 15:00:01 UTC
Re: [CAD_CAM_EDM_DRO] G201 Improvements
Jon Elson
2000-10-29 22:15:53 UTC
Re: [CAD_CAM_EDM_DRO] re: G201 Improvements