Re: [CAD_CAM_EDM_DRO] G201 Improvements

With input from Mariss I designed a little printed circuit baord that can be
used to run the LEDS on the front panel and be able to switch the ouputs on
or off. I'll have the boards Monday or Tuesday. The prototype worked well.
See the pictures at www.metalworking.com look for 4 axisservo*.*
Dan
-----Original Message-----
From: ptengin@... <ptengin@...>
To: CAD_CAM_EDM_DRO@egroups.com <CAD_CAM_EDM_DRO@egroups.com>
Date: Sunday, October 29, 2000 1:18 PM
Subject: Re: [CAD_CAM_EDM_DRO] G201 Improvements

>In a message dated 10/29/2000 4:01:42 AM Hawaiian Standard Time,
>dmauch@... writes:
>
><< One other suggestion is to replace the LED on the board with a polarized
>two
> pin header so that one can bring the LED out to a panel without having to
> add circuitry.
> All in favor say Aye!
> Dan >>
>Aye,
>
>Peter
>THRD, Inc.
>
>Now saving to buy three G320's (hope for same header pins on it).
>
>
>Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the

discussion of shop built systems, for CAD, CAM, EDM, and DRO.

>
>Addresses:
>Post message: CAD_CAM_EDM_DRO@egroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
>List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
>Moderator: jmelson@... [Moderator]
>URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
>FAQ: http://www.ktmarketing.com/faq.html
>bill,
>List Manager
>
>