Re: G201 Improvements
Posted by
Mariss Freimanis
on 2000-10-29 13:30:00 UTC
Hi,
Though it is not stated in the manual, terminal 12 is actually ground
(same as terminal 1). Shorting term. 11 to term. 12 (ground) would
then stop all switching action on the motor terminals, freewheeling
the motor. This could be as simple as a SPST switch across the
current set resistor.
Mariss
Though it is not stated in the manual, terminal 12 is actually ground
(same as terminal 1). Shorting term. 11 to term. 12 (ground) would
then stop all switching action on the motor terminals, freewheeling
the motor. This could be as simple as a SPST switch across the
current set resistor.
Mariss
> I reviewed the G201 manual and I stand on my previous comments.Maybe
> we could pull ONE end of the resistor down/up???
>
> Ballendo
Discussion Thread
Mariss Freimanis
2000-10-28 21:28:40 UTC
G201 Improvements
ballendo@y...
2000-10-29 00:05:30 UTC
re: G201 Improvements
ptengin@a...
2000-10-29 01:45:19 UTC
Re: [CAD_CAM_EDM_DRO] G201 Improvements
Wally K
2000-10-29 03:35:41 UTC
Re: G201 Improvements
Dan Mauch
2000-10-29 06:00:50 UTC
Re: [CAD_CAM_EDM_DRO] G201 Improvements
Tim Goldstein
2000-10-29 06:59:00 UTC
RE: [CAD_CAM_EDM_DRO] G201 Improvements
ballendo@y...
2000-10-29 13:11:45 UTC
Re: G201 Improvements
ptengin@a...
2000-10-29 13:18:54 UTC
Re: [CAD_CAM_EDM_DRO] G201 Improvements
Mariss Freimanis
2000-10-29 13:30:00 UTC
Re: G201 Improvements
ballendo@y...
2000-10-29 13:39:25 UTC
Re: G201 Improvements
Wally K
2000-10-29 14:03:09 UTC
Re: G201 Improvements
ballendo@y...
2000-10-29 14:36:07 UTC
Re: G201 Improvements
Dan Mauch
2000-10-29 15:00:01 UTC
Re: [CAD_CAM_EDM_DRO] G201 Improvements
Jon Elson
2000-10-29 22:15:53 UTC
Re: [CAD_CAM_EDM_DRO] re: G201 Improvements