Re: [CAD_CAM_EDM_DRO] Toothed pully design information needed.

If you can get a Browning Catalog, all the info you need is in there. I've
got an old one but got it long before the web became popular, so I don't
know if they have a web site.

Best thing to do is contact your local supplier and see if they can get a
catalog for you...that's how I got mine.

The only address I have for Browning comes from the catalog:
Browning Manufacturing
Emerson Power Transmission Corp.
Maysville, KY 41056
voice 606 564 2011
fax 606 564 2052

Hope this helps?

Smoke

-----Original Message-----
From: wanliker@... <wanliker@...>
To: CAD_CAM_EDM_DRO@egroups.com <CAD_CAM_EDM_DRO@egroups.com>
Date: Friday, November 10, 2000 7:52 PM
Subject: Re: [CAD_CAM_EDM_DRO] Toothed pully design information needed.

>In a message dated 11/10/00 1:24:52 PM Mountain Standard Time,
>Smoke@... writes:
>
><<
> If your going to cut timing belt pulleys, I'd recomend using a hob and
> cutting them as you would a gear. The edges of the grooves need to be
> rounded over to prevent cutting the blets.
> >>
>but what are the formulas to use?
>
>Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the

discussion of shop built systems, for CAD, CAM, EDM, and DRO.

>
>Addresses:
>Post message: CAD_CAM_EDM_DRO@egroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
>List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
>Moderator: jmelson@... [Moderator]
>URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
>FAQ: http://www.ktmarketing.com/faq.html
>bill,
>List Manager
>
>
>