Re: [CAD_CAM_EDM_DRO] re: tapers post (for smoke)

Nope...the overall length is show but nothein tha thows length of taper.
But John just emailed an attachment and someone just mentioned the angle was
equal to the #40 (3.5"/ft.).

Smoke
-----Original Message-----
From: ballendo@... <ballendo@...>
To: CAD_CAM_EDM_DRO@egroups.com <CAD_CAM_EDM_DRO@egroups.com>
Date: Sunday, November 12, 2000 5:34 PM
Subject: [CAD_CAM_EDM_DRO] re: tapers post (for smoke)

>Smoke
>
>Sure they do. Has small diameter. Has large diameter. Has lengths.
>Angle is implicit.
>
>Hope this helps.
>
>Ballendo
>
>>Unfortunately, the page doesn't show the angles required for R8 and
>>I haven't found anything for 5C either.
>
>
>
>
>
>Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the

discussion of shop built systems, for CAD, CAM, EDM, and DRO.

>
>Addresses:
>Post message: CAD_CAM_EDM_DRO@egroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
>List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
>Moderator: jmelson@... [Moderator]
>URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
>FAQ: http://www.ktmarketing.com/faq.html
>bill,
>List Manager
>
>
>