Re: [CAD_CAM_EDM_DRO] Re: re: tapers post (for smoke)

Ah..thanks...I hadn't gone to the web page that shows the 5C collets. I was
looking at the spindle nose page.

Smoke

-----Original Message-----
From: ballendo@... <ballendo@...>
To: CAD_CAM_EDM_DRO@egroups.com <CAD_CAM_EDM_DRO@egroups.com>
Date: Sunday, November 12, 2000 5:59 PM
Subject: [CAD_CAM_EDM_DRO] Re: re: tapers post (for smoke)

>Smoke,
>
>At:
>
>http://www.cox-internet.com/drspiff/HSM/Collets/Collets.htm
>
>Under R8 OAL is 3.98 . length TO taper is 2.93 . So taper length is
>1.03. As mentioned before, diameters (taper) are given.
>
>Under 5C Length of taper is called out as 16.3 . Again, dia. are
>given.
>
>
>Hope this helps
>
>Ballendo
>
>
>>Nope...the overall length is show but nothein tha thows length of
>>taper.
>>Smoke
>
>
>
>
>Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the

discussion of shop built systems, for CAD, CAM, EDM, and DRO.

>
>Addresses:
>Post message: CAD_CAM_EDM_DRO@egroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
>List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
>Moderator: jmelson@... [Moderator]
>URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
>FAQ: http://www.ktmarketing.com/faq.html
>bill,
>List Manager
>
>
>