CAD CAM EDM DRO - Yahoo Group Archive

re: tapers post (for smoke)

Posted by ballendo@y...
on 2000-11-12 16:36:11 UTC
Smoke

Sure they do. Has small diameter. Has large diameter. Has lengths.
Angle is implicit.

Hope this helps.

Ballendo

>Unfortunately, the page doesn't show the angles required for R8 and
>I haven't found anything for 5C either.

Discussion Thread

ballendo@y... 2000-11-12 16:36:11 UTC re: tapers post (for smoke) Smoke 2000-11-12 16:44:13 UTC Re: [CAD_CAM_EDM_DRO] re: tapers post (for smoke) ballendo@y... 2000-11-12 17:00:57 UTC Re: re: tapers post (for smoke) Smoke 2000-11-12 18:00:59 UTC Re: [CAD_CAM_EDM_DRO] Re: re: tapers post (for smoke) dougrasmussen@c... 2000-11-12 19:28:11 UTC Re: re: tapers post (for smoke) Smoke 2000-11-12 20:12:40 UTC Re: [CAD_CAM_EDM_DRO] Re: re: tapers post (for smoke) dougrasmussen@c... 2000-11-12 20:57:31 UTC Re: re: tapers post (for smoke) Smoke 2000-11-12 22:06:53 UTC Re: [CAD_CAM_EDM_DRO] Re: re: tapers post (for smoke)