Re: [CAD_CAM_EDM_DRO] turn around and go back down

In a message dated 11/20/00 12:26:26 AM Mountain Standard Time, jmw@...
writes:

<< but is it possbile to configure a cog
belt drive so the two cog wheels are not coplanar but 90 degrees
apart (e.g. one wheel is in the X-Y plane and the other in X-Z? >>

Yes you can do it, run the flat side of the belt on flat pulleys with double
flanges, or toothed pulleys on the tooth side again with double flanges.
Like the old Corvair system.
bill