Re: turn around and go back down

Well, that's good news. It would allow orienting the axis of the X
motor in the Y direction. Wouldn't require as long a table extension
for the long aspect ratio motor.

--- In CAD_CAM_EDM_DRO@egroups.com, wanliker@a... wrote:
> In a message dated 11/20/00 12:26:26 AM Mountain Standard Time,
jmw@c...
> writes:
>
> << but is it possbile to configure a cog
> belt drive so the two cog wheels are not coplanar but 90 degrees
> apart (e.g. one wheel is in the X-Y plane and the other in X-Z? >>
>
> Yes you can do it, run the flat side of the belt on flat pulleys
with double
> flanges, or toothed pulleys on the tooth side again with double
flanges.
> Like the old Corvair system.
> bill