Re: turn around and go back down

--- In CAD_CAM_EDM_DRO@egroups.com, wanliker@a... wrote:

> In a message dated 11/20/00 12:26:26 AM Mountain Standard Time,

jmw@c...

> writes:
>
> << but is it possbile to configure a cog
> belt drive so the two cog wheels are not coplanar but 90 degrees
> apart (e.g. one wheel is in the X-Y plane and the other in X-Z? >>
>
> Yes you can do it, run the flat side of the belt on flat pulleys

with double

> flanges, or toothed pulleys on the tooth side again with double

flanges.

> Like the old Corvair system.
> bill

Wally K. replys;

One other tidbit. The gates site says that idler pullys should not
be smaller that the smallest drive pulley.