CAD CAM EDM DRO - Yahoo Group Archive

re:Re: axis naming conventions

Posted by ballendo@y...
on 2000-11-22 13:23:36 UTC
Wally,

The EIA RS-274D standard is for g code, and assumes axis definitions.

I have a copy of the axes definition and naming standard, but I don't
remember its' exact title and I can't get to it just now. Most CNC
textbooks are pretty good about this aspect, if not generally very
good otherwise. Or read my previous posts. Axis names is one of the
FEW areas of CNC where nearly everyone agrees...

Hope this helps.

Ballendo

>"Yes, and this is pretty well backed up by the RS-274D standards
>document<snip>
>Jon E

>>Does this standard have the info you need.
>>Wally K.

Discussion Thread

Jon Elson 2000-11-21 12:01:42 UTC Re: axis naming conventions Smoke 2000-11-21 12:22:13 UTC Re: [CAD_CAM_EDM_DRO] Re: axis naming conventions Jon Elson 2000-11-21 16:03:05 UTC Re: [CAD_CAM_EDM_DRO] Re: axis naming conventions Smoke 2000-11-21 18:30:03 UTC Re: [CAD_CAM_EDM_DRO] Re: axis naming conventions Doug Harrison 2000-11-21 19:21:47 UTC Re: [CAD_CAM_EDM_DRO] Re: axis naming conventions Smoke 2000-11-21 20:05:06 UTC Re: [CAD_CAM_EDM_DRO] Re: axis naming conventions ballendo@y... 2000-11-21 22:19:09 UTC Re: Re: axis naming conventions Wally K 2000-11-22 06:04:30 UTC Re: axis naming conventions Doug Harrison 2000-11-22 06:19:09 UTC Re: [CAD_CAM_EDM_DRO] Re: axis naming conventions Hugh Currin 2000-11-22 09:16:09 UTC Re: axis naming conventions ballendo@y... 2000-11-22 13:23:36 UTC re:Re: axis naming conventions ballendo@y... 2000-11-22 14:24:51 UTC re:Re: axis naming conventions