CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: axis naming conventions

Posted by Doug Harrison
on 2000-11-22 06:19:09 UTC
----- Original Message -----
From: Smoke <Smoke@...>
>
> So, you mount a small lathe on the mill table with the centerline of the
> spindle and tailstock parallel to the X axis on the mill table. Now you
> disconnect the X & Z axis of the mill. Now you have a lathe that will
> travel up and down in the Z direction due to being mounted on the knee.
>
> Now your lathe won't work because the lathe cutting tool is on the wrong
> (Y) axis. Or course you could reconnect the quill axis and mount the
lathe
> tools in the quill.
>
> :)
This is what I love about this group! Where else on earth could someone do
as you just described and not be thought of as a wierd person? I am finally
at home among friends!

;)
Doug

Discussion Thread

Jon Elson 2000-11-21 12:01:42 UTC Re: axis naming conventions Smoke 2000-11-21 12:22:13 UTC Re: [CAD_CAM_EDM_DRO] Re: axis naming conventions Jon Elson 2000-11-21 16:03:05 UTC Re: [CAD_CAM_EDM_DRO] Re: axis naming conventions Smoke 2000-11-21 18:30:03 UTC Re: [CAD_CAM_EDM_DRO] Re: axis naming conventions Doug Harrison 2000-11-21 19:21:47 UTC Re: [CAD_CAM_EDM_DRO] Re: axis naming conventions Smoke 2000-11-21 20:05:06 UTC Re: [CAD_CAM_EDM_DRO] Re: axis naming conventions ballendo@y... 2000-11-21 22:19:09 UTC Re: Re: axis naming conventions Wally K 2000-11-22 06:04:30 UTC Re: axis naming conventions Doug Harrison 2000-11-22 06:19:09 UTC Re: [CAD_CAM_EDM_DRO] Re: axis naming conventions Hugh Currin 2000-11-22 09:16:09 UTC Re: axis naming conventions ballendo@y... 2000-11-22 13:23:36 UTC re:Re: axis naming conventions ballendo@y... 2000-11-22 14:24:51 UTC re:Re: axis naming conventions