CAD CAM EDM DRO - Yahoo Group Archive

Re: EMC-programming request

on 1999-07-16 17:10:23 UTC
In a message dated 7/16/99 1:42:13 AM Eastern Daylight Time,
jmelson@... writes:

<<
Oh, and the microswitch is a bit crude, you want something that can
detect touch with a precision of at least .001". I think a tiny linear
optical encoder can be cobbled up pretty cheaply out of various
bits and pieces. Or, you could get a dial test indicator, pull off the
dial pointer and attach a small encoder disk to the shaft. That was
what I was going to do.
>>



Not exactly sure what you guys are looking for here, but couldn't you make a
probe with some kind if piezio crystal to sense pressure? I would think with
the right circuitry it would be very accurate in the Z axis.
Tracey

Discussion Thread

Dan Falck 1999-07-15 20:33:33 UTC EMC-programming request Tim Goldstein 1999-07-15 22:37:41 UTC RE: EMC-programming request Jon Elson 1999-07-15 22:47:30 UTC Re: EMC-programming request Dan Mauch 1999-07-16 06:42:52 UTC Re: EMC-programming request Ian W. Wright 1999-07-16 13:12:42 UTC Re: EMC-programming request Dan Falck 1999-07-16 16:53:05 UTC EMC-programming request WAnliker@x... 1999-07-16 16:57:08 UTC Re: EMC-programming request TADGUNINC@x... 1999-07-16 17:10:23 UTC Re: EMC-programming request Elliot Burke 1999-07-17 12:36:38 UTC Re: Re: EMC-programming request TADGUNINC@x... 1999-07-17 14:28:10 UTC Re: Re: Re: EMC-programming request Dean Franks 1999-07-17 16:22:17 UTC Re: Re: Re: EMC-programming request John Grant 1999-07-17 19:18:41 UTC Re: Re: Re: EMC-programming request Tim Goldstein 1999-07-17 19:34:38 UTC RE: EMC-programming request Dan Falck 1999-07-17 20:40:35 UTC RE: EMC-programming request Tim Goldstein 1999-07-17 21:13:53 UTC RE: EMC-programming request Elliot Burke 1999-07-18 09:00:56 UTC re: Re: Re: Re: EMC-programming request Fred Proctor 1999-07-19 07:33:07 UTC Re: EMC-programming request Ted Robbins 1999-07-19 08:48:00 UTC Re: EMC-programming request