Re: [CAD_CAM_EDM_DRO] re:defiance vmc wasRe: Re: wrong conversion factor ...

Maybe, maybe not. I've done this little trick before....mix dry sand with
the epoxy. Mix in as much sand as you possibly can and then some. It
doesn't really take much epoxy to bind an awful lot of sand. Use slow
setting epoxy and you'll have plenty of time for mixing the sand ....as well
as getting tired arms. You could possibly fill the cavities nearly full and
then add a layer of epoxy/sand mix to complete the fill. That would save on
epoxy too.

Smoke.

>I think you will find the epoxy is VERY expensive, if you are trying to

fill

>up cavities in castings or extrusions. The epoxy will probably cost

several

>times the cost of the finished casting or extrusion!
>
>Jon
>
>
>Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the

discussion of shop built systems, for CAD, CAM, EDM, and DRO.

>
>Addresses:
>Post message: CAD_CAM_EDM_DRO@egroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
>List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
>Moderator: jmelson@... [Moderator]
>URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
>FAQ: http://www.ktmarketing.com/faq.html
>bill,
>List Manager
>
>
>