Re: [CAD_CAM_EDM_DRO] Re: Laptop Computer

Ron: Not so on a IBM ThinkPad. When you turn off the laptop while running CNCPro it reboots back to CNCPro.

Ron Moore wrote:

> Rich,
> When in DOS mode, there is no need to "Shut Down" the operating
> system. Once you're at a DOS prompt (C:\) just turn the unit off with
> the power switch. It will load Win9x on the next bootup sequence.
>
> A bit of parts gloat, I got a call from on of the local surplus
> companies last week about a mag-opt disk library being salvaged. I
> got two Lintech twinrail sections over 36" long with all the slides,
> etc and a bar-slide arrangement (also over 3 feet) that ran a
> cartridge loader carrier. It has Technology Inc. MFM motors with
> cogbelt gear reduction drive on them. Should make a great base for a
> CNC engraver system. Now I need to get some space to start putting
> all these parts that I've been collecting into something productive.
> Respectfully,
> Ron Moore
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager