Re: [CAD_CAM_EDM_DRO] Re: lubricants was Re: Re: spindle motors
Posted by
Jon Elson
on 2000-12-16 21:23:11 UTC
Geoff Bullough wrote:
Lubricants back then were a lot less sophisticated, and vaseline may
have been as good as anything available then. I suspect that any
machine maker would laugh at using such a lubricant now!
Jon
> I have an Alexander/Deckel 3 dimensional pantograph diesinking machine (bigger motor and a lot beefier than an engraver). The manual says " the high speed ball bearing spindle should be filled with petroleum jelly at least once a month"..I take it this is probably an older machine, at least 20 - 30 years old.
> Vaseline - yes, that surprised me too, but that's what the book says.
>
> Geoff Bullough
> England
Lubricants back then were a lot less sophisticated, and vaseline may
have been as good as anything available then. I suspect that any
machine maker would laugh at using such a lubricant now!
Jon
Discussion Thread
ballendo@y...
2000-12-14 15:35:36 UTC
lubricants was Re: Re: spindle motors
Doug Harrison
2000-12-14 17:48:12 UTC
Re: [CAD_CAM_EDM_DRO] lubricants was Re: Re: spindle motors
Smoke
2000-12-14 18:00:19 UTC
Re: [CAD_CAM_EDM_DRO] lubricants was Re: Re: spindle motors
Smoke
2000-12-14 18:22:52 UTC
Re: [CAD_CAM_EDM_DRO] lubricants was Re: Re: spindle motors
dave engvall
2000-12-14 21:08:22 UTC
Re: [CAD_CAM_EDM_DRO] lubricants was Re: Re: spindle motors
Jon Elson
2000-12-14 21:54:46 UTC
Re: [CAD_CAM_EDM_DRO] lubricants was Re: Re: spindle motors
Smoke
2000-12-14 22:04:50 UTC
Re: [CAD_CAM_EDM_DRO] lubricants was Re: Re: spindle motors
Smoke
2000-12-14 22:08:46 UTC
Re: [CAD_CAM_EDM_DRO] lubricants was Re: Re: spindle motors
Jon Elson
2000-12-15 12:08:56 UTC
Re: [CAD_CAM_EDM_DRO] lubricants was Re: Re: spindle motors
Geoff Bullough
2000-12-16 01:25:12 UTC
Re: lubricants was Re: Re: spindle motors
Jon Elson
2000-12-16 21:23:11 UTC
Re: [CAD_CAM_EDM_DRO] Re: lubricants was Re: Re: spindle motors