Re: [CAD_CAM_EDM_DRO] quick EMC question
Posted by
Les Watts
on 2001-01-07 11:12:39 UTC
Sounds good, Matt.
EMC on a large industrial gantry machine might be a very good match.
If I can be playing around with install issues while the parallel port thing
is tried it should time about right.
If EMC runs solidly I will buy the stg card if I have to. I must face the
fact that all my old favorite LM628 software that I
have written over the years may get orphaned as the old hardware goes away.
I still have some mechanical issues to deal with as well...
way covers and such.
Also have some minor tronics to do. I am whipping up a little
dual optical shutter speed sensor to detect runaway rapids.
Just uses a 555 and a couple of logic gates.
A runaway velocity mode caused by a shorted output transistor would not be a
good thing with 1000 lb+ moving mass!
Thanks
Les
Leslie Watts
L M Watts Furniture
Tiger, Georgia USA
http://www.rabun.net/~leswatts/wattsfurniturewp.html
EMC on a large industrial gantry machine might be a very good match.
If I can be playing around with install issues while the parallel port thing
is tried it should time about right.
If EMC runs solidly I will buy the stg card if I have to. I must face the
fact that all my old favorite LM628 software that I
have written over the years may get orphaned as the old hardware goes away.
I still have some mechanical issues to deal with as well...
way covers and such.
Also have some minor tronics to do. I am whipping up a little
dual optical shutter speed sensor to detect runaway rapids.
Just uses a 555 and a couple of logic gates.
A runaway velocity mode caused by a shorted output transistor would not be a
good thing with 1000 lb+ moving mass!
Thanks
Les
Leslie Watts
L M Watts Furniture
Tiger, Georgia USA
http://www.rabun.net/~leswatts/wattsfurniturewp.html
Discussion Thread
Les Watts
2001-01-07 07:54:28 UTC
quick EMC question
Matt Shaver
2001-01-07 09:58:55 UTC
Re: [CAD_CAM_EDM_DRO] quick EMC question
Les Watts
2001-01-07 11:12:39 UTC
Re: [CAD_CAM_EDM_DRO] quick EMC question
Matt Shaver
2001-01-07 12:17:22 UTC
Re: [CAD_CAM_EDM_DRO] quick EMC question
Les Watts
2001-01-07 14:45:34 UTC
Re: [CAD_CAM_EDM_DRO] quick EMC question
Dan Falck
2001-01-07 14:50:48 UTC
Re: quick EMC question
Jon Elson
2001-01-07 19:25:58 UTC
Re: [CAD_CAM_EDM_DRO] quick EMC question
Jon Elson
2001-01-07 20:07:02 UTC
Re: [CAD_CAM_EDM_DRO] quick EMC question
Les Watts
2001-01-08 08:21:47 UTC
Re: [CAD_CAM_EDM_DRO] quick EMC question
Jon Elson
2001-01-08 11:28:39 UTC
Re: [CAD_CAM_EDM_DRO] quick EMC question
Les Watts
2001-01-08 12:11:46 UTC
Re: [CAD_CAM_EDM_DRO] quick EMC question
ballendo@y...
2001-01-08 16:50:19 UTC
re:Re: quick EMC question