Re: [CAD_CAM_EDM_DRO] 2-D shape Cutting solutions.

Joe,
What program and controller did you use?
Would one be able to use DXF to run it?
And what plasma setup did you use?

Joe Vicars wrote:

> Hans,
> I have heard rumors about "portable" water jets, but until then... Plasma.
> I built one that will do like 11" by 23" for almost nothin. The envelope is basically the limit of two belts spliced together. It
> uses belts and linear bearings.
> I am busy with my milling, and I moved to a very small shop and have to do all plasma outside so I dont' use it any more.
> It used 2, 34 step motors (one later died). I rigged up an automatic trigger with a solenoid and put it on the plasma handle
> with zip ties. It worked pretty good. I made a trailer, trailer hitch and a bunch of stuff before the motor went out. It was
> direct drive, really fast (200 ipm) with about a .015" resolution
> I would probably sell it for almost nothin if anyone was interesed. (just the mechanism and the motors, not the plasma or the
> control)
>
> Hans Vogel wrote:
>
> > Ladies and Gentlmen,
> >
> > I have worked with a water jet 2D CnC shape cutter and it would suit my
> > needs in a hobby respect except that they are cost prohibitive.
> >
> > I would like info on building a 2D shape cutter. If I understand
> > correctly the stepper motor and machine superstructure would not be that
> > difficult, its the cutter,
> > I am looking to build something that will cut 4'X4' sheetmetal up to say
> > 1/4" steel.
> >
> > Thanks
> >
> > [Non-text portions of this message have been removed]
> >
> > Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
> >
> > Addresses:
> > Post message: CAD_CAM_EDM_DRO@egroups.com
> > Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> > Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> > List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> > Moderator: jmelson@... [Moderator]
> > URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> > FAQ: http://www.ktmarketing.com/faq.html
> > bill,
> > List Manager
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager

[Non-text portions of this message have been removed]