Re: [CAD_CAM_EDM_DRO] re:Re: G92 and M99 code/cncpro

Ballendo: The unexpected move was probably just in the z axis. And it
was at a very rapid speed. Sort of a zip-crunch at about the same speed
that it took you to read zip-crunch. I ran three more identical parts
from the same file(unchanged) without a problem.A whole bunch of extra
steps came from somewhere, not from the gcode. I did not ask Doug about
the problem. I guess that I should.It would surely be easier on my
nerves if I knew for certain that it wouldn't happen again. The code was
generated from BobCad17 in lathe mode.
Carey