re:Re: G92 and M99 code/cncpro

Tauseef,

This sounds a lot like a problem I had with CncPRO. Z axis 'dropping'
over time. I checked all the mechanical reasons, even flipped axes
cables and watched it happen on y (so that eliminates gravity/ weak
motor,etc.) I think it is a BUG! I've stopped using CncPRO because of
it. I'm guessing some accel/decel code is being "tripped up" in
certain instances where there is a lot of z axis motion relative to
XY motion. (at least that describes my experience. And yours!)

I asked others using CncPRO to comment awhile back, and got no
response. Maybe now???

Ballendo

>hey guys, my example below does not work right. After making the
>numbers a little bigger I noticed that when the spindle is moving to
>the new position for the next hole it also moves down :( It does
>loop 50 times as in the example.
>tauseef