CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Semi-homebrew PCB Router W/X-Y Table?

Posted by Henry Palonen
on 2001-03-15 05:05:00 UTC
* The AntiYuppie (sloboyko@...) [10.03.2001 06:27]:
>
> 3. I found a few pieces of software on the 'Net that seem like they
> could control these things for PCB and engraving. Is anybody doing
> anything similar. What do you use?

Hello.

I'm using Eagle 4.0 software (free version) to produce PCB's and needed tool-paths
for EMC software (also free). Converting from Eagle's CAM-output to EMC's CAM-input
can be a little painfull unless you use some converter. (I did converter in perl, but it can be
easily made with any programming language.) But after conversion
it works quite nicely. I have some information about process in my
pages, http://www.yty.net/cnc.

Regards,

Henry "Henkka" Palonen, OH6KFT
h@...

Discussion Thread

The AntiYuppie 2001-03-09 20:24:58 UTC Semi-homebrew PCB Router W/X-Y Table? Tim Goldstein 2001-03-09 21:45:44 UTC RE: [CAD_CAM_EDM_DRO] Semi-homebrew PCB Router W/X-Y Table? Jon Elson 2001-03-09 21:55:22 UTC Re: [CAD_CAM_EDM_DRO] Semi-homebrew PCB Router W/X-Y Table? kleinbauer@j... 2001-03-10 19:00:28 UTC Re: Semi-homebrew PCB Router W/X-Y Table? Neil Gillies 2001-03-11 00:23:07 UTC RE: Semi-homebrew PCB Router W/X-Y Table? Tom Eldredge 2001-03-11 09:07:56 UTC Re: [CAD_CAM_EDM_DRO] RE: Semi-homebrew PCB Router W/X-Y Table? Greg Hensley 2001-03-14 16:17:24 UTC Re: [CAD_CAM_EDM_DRO] Semi-homebrew PCB Router W/X-Y Table? Henry Palonen 2001-03-15 05:05:00 UTC Re: [CAD_CAM_EDM_DRO] Semi-homebrew PCB Router W/X-Y Table? Alan Marconett KM6VV 2001-03-15 10:52:37 UTC Re: Semi-homebrew PCB Router W/X-Y Table? timg@k... 2001-03-26 14:30:27 UTC Re: Semi-homebrew PCB Router W/X-Y Table?