Re: [CAD_CAM_EDM_DRO] CNC grinding & wheel dressing
Posted by
Jon Elson
on 2001-03-19 11:34:10 UTC
Tom Eldredge wrote:
rotation. What you want to avoid is the diamond leaning into the direction
of rotation. This could cause a slight vibration that causes the diamond
point to dig in a bit to keep digging in deeper until the wheel bursts.
With the point leaning away, it will tend to deflect away from the wheel
under increased pressure.
Jon
> Gentlemen,What you want is the point 'leaning' away from the direction of wheel
>
> When dressing a wheel, should the angle be slightly greater or less than 90
> degrees?
rotation. What you want to avoid is the diamond leaning into the direction
of rotation. This could cause a slight vibration that causes the diamond
point to dig in a bit to keep digging in deeper until the wheel bursts.
With the point leaning away, it will tend to deflect away from the wheel
under increased pressure.
Jon
Discussion Thread
ron ginger
2001-03-14 16:51:29 UTC
CNC grinding & wheel dressing
IMService
2001-03-14 18:41:01 UTC
Re: CNC grinding & wheel dressing
Smoke
2001-03-14 20:35:08 UTC
Re: [CAD_CAM_EDM_DRO] CNC grinding & wheel dressing
Jon Anderson
2001-03-14 20:54:23 UTC
Re: [CAD_CAM_EDM_DRO] CNC grinding & wheel dressing
Joe Vicars
2001-03-15 05:33:47 UTC
Re: [CAD_CAM_EDM_DRO] CNC grinding & wheel dressing
Marcus & Eva
2001-03-15 20:44:41 UTC
Re: [CAD_CAM_EDM_DRO] CNC grinding & wheel dressing
ballendo@y...
2001-03-16 04:31:37 UTC
Re: CNC grinding & wheel dressing
Geoffrey Brown
2001-03-16 17:10:54 UTC
Re: CNC grinding & wheel dressing
Marcus & Eva
2001-03-17 08:32:59 UTC
Re: [CAD_CAM_EDM_DRO] Re: CNC grinding & wheel dressing
Tom Eldredge
2001-03-19 08:35:22 UTC
Re: [CAD_CAM_EDM_DRO] CNC grinding & wheel dressing
Joe Vicars
2001-03-19 08:48:12 UTC
Re: [CAD_CAM_EDM_DRO] CNC grinding & wheel dressing
Tim Goldstein
2001-03-19 09:24:00 UTC
RE: [CAD_CAM_EDM_DRO] CNC grinding & wheel dressing
Jon Elson
2001-03-19 11:34:10 UTC
Re: [CAD_CAM_EDM_DRO] CNC grinding & wheel dressing
Jon Anderson
2001-03-19 12:51:02 UTC
Re: [CAD_CAM_EDM_DRO] CNC grinding & wheel dressing
Tom Eldredge
2001-03-20 06:37:54 UTC
Re: [CAD_CAM_EDM_DRO] CNC grinding & wheel dressing