Re: [CAD_CAM_EDM_DRO] Re: Going home
Posted by
ptengin@a...
on 2001-03-21 11:34:56 UTC
In a message dated 03/21/2001 12:22:59 AM Hawaiian Standard Time,
ballendo@... writes:
I tried the movable home idea. Unless you document all your part programs
real well, you will not know if the tool will gracefully enter the cut or
violently stab your part. Been there done that a few times.... And it is not
a pretty picture.
Peter
THRD, Inc.
[Non-text portions of this message have been removed]
ballendo@... writes:
> So put the Home switch at the top of mill Z (and W) axis travel, andIan,
> use the rich set of g code to deal with the other "points" you'd like
> to return to...
>
> Hope this helps.
>
> Ballendo
>
>
I tried the movable home idea. Unless you document all your part programs
real well, you will not know if the tool will gracefully enter the cut or
violently stab your part. Been there done that a few times.... And it is not
a pretty picture.
Peter
THRD, Inc.
[Non-text portions of this message have been removed]
Discussion Thread
Ian Wright
2001-03-20 15:08:56 UTC
Going home
kleinbauer@j...
2001-03-20 15:36:54 UTC
Re: Going home
Jon Elson
2001-03-20 16:19:40 UTC
Re: [CAD_CAM_EDM_DRO] Going home
Smoke
2001-03-20 16:58:50 UTC
Re: [CAD_CAM_EDM_DRO] Going home
Brian Pitt
2001-03-20 23:15:29 UTC
Re: [CAD_CAM_EDM_DRO] Going home
ballendo@y...
2001-03-21 02:20:59 UTC
Re: Going home
Ian Wright
2001-03-21 02:21:30 UTC
Re: [CAD_CAM_EDM_DRO] Going home
Ian Wright
2001-03-21 02:25:04 UTC
Re: [CAD_CAM_EDM_DRO] Re: Going home
ballendo@y...
2001-03-21 02:48:27 UTC
faster steppers was Re: Going home
Ian Wright
2001-03-21 03:34:48 UTC
Re: [CAD_CAM_EDM_DRO] faster steppers was Re: Going home
ptengin@a...
2001-03-21 11:34:56 UTC
Re: [CAD_CAM_EDM_DRO] Re: Going home
Ray
2001-03-21 11:43:25 UTC
Re: faster steppers was Re: Going home
Jon Elson
2001-03-21 12:57:31 UTC
Re: [CAD_CAM_EDM_DRO] Going home
ballendo@y...
2001-03-22 06:59:00 UTC
faster steppers was Re: Going home