CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: Going home

Posted by Ian Wright
on 2001-03-21 02:25:04 UTC
Thanks Ballendo, this is very helpful info - I'll change my mind about
having a moving home position as Smoke suggested and go back to putting it
at the top of the 'Z' axis.

Ian
--
Ian W. Wright
Sheffield UK
www.iw63.freeserve.co.uk
----- Original Message -----
From: <ballendo@...>
: [CAD_CAM_EDM_DRO] Re: Going home


> > Why not make the home switch adjustable like it is on my mill?
> > Smoke
>
> Smoke, List,
>
> Depending on your use of the machine, this can be a bad thing... Home
> is a REFERENCE position, from which ALL other coordinates (on the
> axis) are determined...
>
> If your home is adjustable, how do you "go back" to something you set
> up last week? Without setting it up again? A fixed home position

Discussion Thread

Ian Wright 2001-03-20 15:08:56 UTC Going home kleinbauer@j... 2001-03-20 15:36:54 UTC Re: Going home Jon Elson 2001-03-20 16:19:40 UTC Re: [CAD_CAM_EDM_DRO] Going home Smoke 2001-03-20 16:58:50 UTC Re: [CAD_CAM_EDM_DRO] Going home Brian Pitt 2001-03-20 23:15:29 UTC Re: [CAD_CAM_EDM_DRO] Going home ballendo@y... 2001-03-21 02:20:59 UTC Re: Going home Ian Wright 2001-03-21 02:21:30 UTC Re: [CAD_CAM_EDM_DRO] Going home Ian Wright 2001-03-21 02:25:04 UTC Re: [CAD_CAM_EDM_DRO] Re: Going home ballendo@y... 2001-03-21 02:48:27 UTC faster steppers was Re: Going home Ian Wright 2001-03-21 03:34:48 UTC Re: [CAD_CAM_EDM_DRO] faster steppers was Re: Going home ptengin@a... 2001-03-21 11:34:56 UTC Re: [CAD_CAM_EDM_DRO] Re: Going home Ray 2001-03-21 11:43:25 UTC Re: faster steppers was Re: Going home Jon Elson 2001-03-21 12:57:31 UTC Re: [CAD_CAM_EDM_DRO] Going home ballendo@y... 2001-03-22 06:59:00 UTC faster steppers was Re: Going home