Re: [CAD_CAM_EDM_DRO] Going home
Posted by
Jon Elson
on 2001-03-21 12:57:31 UTC
Ian Wright wrote:
the gear-down ratio is too high for such a fine leadscrew. Do you really
need that much reduction?
Jon
> Thanks everyone,Well, I think its quite clear that you either have motors that are too small, or
>
> Even if there are varying views in positioning of the home switch (as I
> really expected), I (and hopefully others) now have some very useful
> information on setting tool lengths etc. I quite like Smoke's idea of having
> a moving home switch but quite how I could implement that I'm not sure -
> I'll go and find my thinking cap!
>
> Jon, the motor driver are fairly basic L278/279 combinations with current
> setback and running in half step mode. The motors are surplus and, as near
> as I can tell they are about 5volt, 1.5 amp. At the moment it seems that the
> best speed I can get out of them without losing steps is 210 r.p.m. In my
> case this is taken through a 3:1 reduction to a 1mm pitch leadscrew which
> therefore gives me 70mm / min or 2.75" / min!
the gear-down ratio is too high for such a fine leadscrew. Do you really
need that much reduction?
Jon
Discussion Thread
Ian Wright
2001-03-20 15:08:56 UTC
Going home
kleinbauer@j...
2001-03-20 15:36:54 UTC
Re: Going home
Jon Elson
2001-03-20 16:19:40 UTC
Re: [CAD_CAM_EDM_DRO] Going home
Smoke
2001-03-20 16:58:50 UTC
Re: [CAD_CAM_EDM_DRO] Going home
Brian Pitt
2001-03-20 23:15:29 UTC
Re: [CAD_CAM_EDM_DRO] Going home
ballendo@y...
2001-03-21 02:20:59 UTC
Re: Going home
Ian Wright
2001-03-21 02:21:30 UTC
Re: [CAD_CAM_EDM_DRO] Going home
Ian Wright
2001-03-21 02:25:04 UTC
Re: [CAD_CAM_EDM_DRO] Re: Going home
ballendo@y...
2001-03-21 02:48:27 UTC
faster steppers was Re: Going home
Ian Wright
2001-03-21 03:34:48 UTC
Re: [CAD_CAM_EDM_DRO] faster steppers was Re: Going home
ptengin@a...
2001-03-21 11:34:56 UTC
Re: [CAD_CAM_EDM_DRO] Re: Going home
Ray
2001-03-21 11:43:25 UTC
Re: faster steppers was Re: Going home
Jon Elson
2001-03-21 12:57:31 UTC
Re: [CAD_CAM_EDM_DRO] Going home
ballendo@y...
2001-03-22 06:59:00 UTC
faster steppers was Re: Going home