Re: [CAD_CAM_EDM_DRO] Cable Sources/Recommendations?

ptengin@... wrote:

> In a message dated 3/21/01 8:49:36 PM Hawaiian Standard Time,
> mshaver@... writes:
>
> << Another issue I've been thinking about is the connectors for the motor
> and encoder cables. Most traditional controls use Amphenol MS series
> circular metal shell connectors which are rather expensive ($20-$30 each
> for a plug or receptacle). Some newer machines like Haas and Fadal have
> their own rectangular plastic or die cast shell connectors with the
> company name molded in. I'll have to dig around and see what's available
> now.

The AMP circular plastic connector is a real good way to go. I used 37-pin
ones, which is maybe overkill, but I wanted everything for an axis on one
connector - motor, tach, encoder, limit switches, etc. They are much cheaper
than almost any other type, can carry a good amount of current, have different
insertable pins for different gauges of wire, and are quite robust. It is very
handy when something goes wrong, and you can swap axis drives in seconds
to troubleshoot. I got mine from Digi-Key.

Jon