Re: [CAD_CAM_EDM_DRO] EMC parallel port pin assignments

I think you will need to get out the soldering iron. The good news is you
can then configure your demo cncpro to match EMC..
Joel

----- Original Message -----
From: <rab@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Tuesday, March 27, 2001 11:41 AM
Subject: [CAD_CAM_EDM_DRO] EMC parallel port pin assignments


> Is it possible to change EMC's parallel port pin assignments for step
> and direction signals or do I need to get the soldering iron out ?
> ( I set up my test-bed pin-outs for the CNC Pro demo )
>
>
> Thanks,
> Rab
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>