Re: [CAD_CAM_EDM_DRO] EMC parallel port pin assignments
Posted by
William Scalione
on 2001-03-27 17:13:37 UTC
Rab,
While you still need to get your soldering iron out, this works pretty good.
Go to radio shack and get a 25 pin serial port jumper box. (not sure of
the exact name) It's got a 25 pin D-sub connector on each end connected
together by a small circuit board. It comes with wires to jumper the pins
and you can make one for each software version you try.
BTW I realize that we are not using the serial port but it works fine on the
parallel port.
Bill
While you still need to get your soldering iron out, this works pretty good.
Go to radio shack and get a 25 pin serial port jumper box. (not sure of
the exact name) It's got a 25 pin D-sub connector on each end connected
together by a small circuit board. It comes with wires to jumper the pins
and you can make one for each software version you try.
BTW I realize that we are not using the serial port but it works fine on the
parallel port.
Bill
> Is it possible to change EMC's parallel port pin assignments for step
> and direction signals or do I need to get the soldering iron out ?
> ( I set up my test-bed pin-outs for the CNC Pro demo )
>
>
> Thanks,
> Rab
>
>
Discussion Thread
rab@r...
2001-03-27 08:41:04 UTC
EMC parallel port pin assignments
Tim Goldstein
2001-03-27 10:06:35 UTC
RE: [CAD_CAM_EDM_DRO] EMC parallel port pin assignments
John Murphy
2001-03-27 10:52:20 UTC
Re: [CAD_CAM_EDM_DRO] EMC parallel port pin assignments
Joel Jacobs
2001-03-27 10:57:40 UTC
Re: [CAD_CAM_EDM_DRO] EMC parallel port pin assignments
William Scalione
2001-03-27 17:13:37 UTC
Re: [CAD_CAM_EDM_DRO] EMC parallel port pin assignments
cadman@p...
2001-03-27 22:26:45 UTC
Re: EMC parallel port pin assignments
Tim Goldstein
2001-03-27 22:29:51 UTC
RE: [CAD_CAM_EDM_DRO] Re: EMC parallel port pin assignments
Dan Mauch
2001-03-28 06:51:20 UTC
Re: [CAD_CAM_EDM_DRO] EMC parallel port pin assignments
Alan Marconett KM6VV
2001-03-28 11:01:58 UTC
Re: EMC parallel port pin assignments
Paul
2001-03-28 12:07:29 UTC
Re: [CAD_CAM_EDM_DRO] EMC parallel port pin assignments