CAD CAM EDM DRO - Yahoo Group Archive

Re: EMC parallel port pin assignments

Posted by cadman@p...
on 2001-03-27 22:26:45 UTC
By the way. Can anyone tell me what the pin outs are for EMC. I am
going to be building my servo controller box from Camtronics and I may
as well use these pin outs since EMC is fixed and CNC-pro can be
changed.

CADMAN


--- In CAD_CAM_EDM_DRO@y..., "William Scalione" <wscalione@n...>
wrote:
> Rab,
>
> While you still need to get your soldering iron out, this works
pretty good.
> Go to radio shack and get a 25 pin serial port jumper box. (not sure
of
> the exact name) It's got a 25 pin D-sub connector on each end
connected
> together by a small circuit board. It comes with wires to jumper the
pins
> and you can make one for each software version you try.
> BTW I realize that we are not using the serial port but it works
fine on the
> parallel port.
>
> Bill
>
> > Is it possible to change EMC's parallel port pin assignments for
step
> > and direction signals or do I need to get the soldering iron out ?
> > ( I set up my test-bed pin-outs for the CNC Pro demo )
> >
> >
> > Thanks,
> > Rab
> >
> >

Discussion Thread

rab@r... 2001-03-27 08:41:04 UTC EMC parallel port pin assignments Tim Goldstein 2001-03-27 10:06:35 UTC RE: [CAD_CAM_EDM_DRO] EMC parallel port pin assignments John Murphy 2001-03-27 10:52:20 UTC Re: [CAD_CAM_EDM_DRO] EMC parallel port pin assignments Joel Jacobs 2001-03-27 10:57:40 UTC Re: [CAD_CAM_EDM_DRO] EMC parallel port pin assignments William Scalione 2001-03-27 17:13:37 UTC Re: [CAD_CAM_EDM_DRO] EMC parallel port pin assignments cadman@p... 2001-03-27 22:26:45 UTC Re: EMC parallel port pin assignments Tim Goldstein 2001-03-27 22:29:51 UTC RE: [CAD_CAM_EDM_DRO] Re: EMC parallel port pin assignments Dan Mauch 2001-03-28 06:51:20 UTC Re: [CAD_CAM_EDM_DRO] EMC parallel port pin assignments Alan Marconett KM6VV 2001-03-28 11:01:58 UTC Re: EMC parallel port pin assignments Paul 2001-03-28 12:07:29 UTC Re: [CAD_CAM_EDM_DRO] EMC parallel port pin assignments